21 Comments

  1. ReCycle Spinning
    May 26, 2019 @ 7:57 am

    Gotta be an easier way to do this.i have done several. I do home remodel professionally and every time I do one I think there should be an easier way. . Maybe a make a form and then just pour some reinforced concrete… I mean cement finishers pour and pitch cement all day long…..

    Reply

  2. Rick the Swift
    June 3, 2019 @ 4:48 pm

    This is a great shower floor demonstration where Brett Favre gives some classy tips on how he gets things done 🙂

    Reply

  3. darkness rises
    June 3, 2019 @ 7:05 pm

    Great video. I've been watching videos for the last 2 hours and had basically been distracted by other things, but your video grabbed my attention back to the tv. Thank you for sharing your knowledge!

    Reply

  4. Larry Oslund
    June 10, 2019 @ 3:14 pm

    Great Video Rusty – I do have a question. I just poured my "first" layer (the one that goes under the liner) over the weekend and tried to follow your instructions. Everything went great except that I could never get a smooth surface to the wet-pack like you did, no matter how much I tried to float it. Did I just not have enough water in it? My surface is "rough" to the touch now. The sloping is fine. . There is nothing really "sharp" sticking up, it is just not the smooth you show in your video where I think the portal cement and water gets pulled to the top while floating. Do I need to "pour" another thin layer over this and float it smooth, or is it OK to lay the liner over this. Thanks in advance for you reply (larryoslund@gmail.com) – I can send you a pick if you email me.

    Reply

  5. TJ Gallo
    June 12, 2019 @ 6:15 am

    FINALLY!!! Rusty, you are truly a GREAT teacher that understands how to speak at appropriate speed, giving your audience a comprehensive and thorough explanations of the most relevant terms, ideas, reasons, expectations, etc. You did an incredible job of editing your video to match your audio with your video, maximizing all teaching opportunities. I can't say enough how great you are at not only your trade, but also at teaching your trade via video to you youtube audience. All the best successes to you on your journey Rusty!! Your contribution here is incredible and you most certainly deserve every bit of the success that you procure from it!

    Reply

  6. Carlos Rodriguez
    June 29, 2019 @ 9:42 pm

    .

    Reply

  7. Rob D
    July 9, 2019 @ 6:48 am

    So I leave a 1/4 inch space between subfloor and drain before I pour the first preslope so it lines up flush after preslope?? Thank you!

    Reply

  8. MrEverything
    August 9, 2019 @ 8:23 pm

    You can also just make a small form, and use cement instead of brick for that area.

    Reply

  9. Piotr 75
    August 10, 2019 @ 9:45 pm

    The perimeter of the shower floor does not look very level

    Reply

  10. Tonathiu Ruiz
    August 17, 2019 @ 4:01 am

    Thank You!!

    Reply

  11. Joanne James
    August 23, 2019 @ 10:31 pm

    Excellent. Thank you.

    Reply

  12. Fredrickthegreat
    September 13, 2019 @ 2:26 am

    Like pie crust

    Reply

  13. Kathy Burton
    September 21, 2019 @ 9:14 pm

    Do you have a list of all the material that is needed for the floor?

    Reply

  14. howard bonds
    September 23, 2019 @ 11:51 pm

    Does anyone know the name and type of those shower tiles he was putting in?! thats exactly what I have been looking for!

    Reply

  15. Josh Washington
    November 6, 2019 @ 3:37 am

    Destruction during demo for my house was fun. Cleanup was not. Complete overhaul and rebuilding was fun! Getting inspections during permit phases because I didn't hire a contractor was not. (because I'm a 30 year old who prefers to learn instead of paying four times the material cost for someone to do it for me)
    Loved your videos. Still watching some. The floating shelf one (the 'strongest floating shelf') started on this binge. Keep it up! 🙂

    Reply

  16. Self identified as An Apache helicopter
    November 13, 2019 @ 9:53 pm

    Should’ve used pressure treated wood 🤦‍♂️

    Reply

  17. Moist and Squishy
    November 14, 2019 @ 3:12 am

    I hate drains that are right-dab in the center of where you stand to shower… PUT THE DRAIN ON THE CORNER OR SIDE!!!

    Reply

  18. Darrick16255
    November 17, 2019 @ 11:09 am

    A

    Reply

  19. OMGWTFLOL
    November 26, 2019 @ 7:29 am

    Great video. This method is fine for a custom shower but if you are happy with something more standard, I'd use an existing shower pan, like from Wedi Board. It's much easier with much less labour. https://www.youtube.com/watch?v=3Eu_CD6YPfg

    Reply

  20. Earl Eidecker
    November 28, 2019 @ 8:52 am

    Brother if you're ever out in Arizona stop on bye I love you man you helped me out a lot with this video

    Reply

  21. john guadalupe
    December 6, 2019 @ 4:45 am

    Great videos Rusty, question , i see some people using pee gravel? do i need to use it or just tape the weep holes? i did not see any in your video, thank you again

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *